Rastergraf Eclipse3 Series Manual do Utilizador descarregar pdf (Página 31)

Rastergraf

General Information 1-23

1.6 Monitor Requirements

Rastergraf graphics boards can be used with a variety of monitors. For

best performance a monitor should have the following features:

• VGA compatible 5 Wire RGB with separate TTL horizontal and

vertical sync or 3 Wire RGB with sync on green (see note below)

• Switchable Termination (for monitor loopthrough)

• Height, pincushion, width, phase, and position controls

• Autotracking horizontal and vertical synchronization

• See tables in Section 1.4 (above) for basic timing requirements

Notes

The Eclipse3 software defaults to standard Multiscan 5-wire RGBHV

(VGA compatible) settings. If you require Sync On Green, be sure to

install SYNC ON GREEN jumper.

Eclipse3 graphics boards DO NOT support interlaced operation.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 84 85

Sem comentários

Rastergraf Eclipse3 Series Manual do Utilizador Página 31